 | | Motor Ports
|
|
Hi all, Is it possible to add more motor ports to the handy board by simply copying the existing motor drive circuit and putting them on the expansion header where the extra chip select lines are. if so what changes would be needed to make IC (...) (28 years ago, 11-Jan-99, to lugnet.robotics.handyboard)
|
| |
| | motor ports
|
|
Hi all, Is it possible to add more motor ports to the handy board by simply copying the existing motor drive circuit and putting them on the expansion header where the extra chip select lines are. if so what changes would be needed to make IC (...) (28 years ago, 11-Jan-99, to lugnet.robotics.handyboard)
|
| |
| | Expansion board motor outs???
|
|
I just wanted to verify something before I went and purchased the expansion board. Are the HB's motor outputs still available when using the expansion board. It is unclear in the doc. Thanks, Aaron (28 years ago, 11-Jan-99, to lugnet.robotics.handyboard)
|
| |
| | Wireless Handyboard Link ?
|
|
Hello, I am investigating createing a wireless serial link between my PC and handyboard. The cheapest solution I've found is the RF module from Lynxmotion. Does anyone have any experience with this, or perhaps suggestions for simpler or more (...) (28 years ago, 11-Jan-99, to lugnet.robotics.handyboard)
|
| |
| | Re: HB and Acceleration
|
|
(...) I presume that you are not planning on using my infrared control software! Good luck in your project, it sounds like fun. Wanna tell us more about it? /Max (28 years ago, 11-Jan-99, to lugnet.robotics.handyboard)
|
