 | | Fwd: Re. RF data link
|
|
-- MIME ATTACHMENTS DISCARDED: 1. Content-ID: <0_913320756@inet_ou...aol.com.2> Content-type: message/rfc822 Content-transfer-encoding: 7bit Content-disposition: inline Content-Length: 1259 (27 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | How to get digital outputs from the handyboard???...???
|
|
hi everyone, i have been trying for the past few days to get digital outputs from the board but with no success. i have been trying to get digitals outputs from the SPI's pins (J6). i have poke to make the port as output port. but the problem now is (...) (27 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | Servos for the miniboard
|
|
I would like to use a servo to operate the throttle of a small gas engine. I am planning on using the miniboard to control the servo. Are there any brands to avoid? Are there any brands that are far better than the rest? Will just about any RC servo (...) (27 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | How to get digital outputs from the handyboard???...???
|
|
hi everyone, i have been trying for the past few days to get digital outputs from the board but with no success. i have been trying to get digitals outputs from the SPI's pins (J6). i have poke to make the port as output port. but the problem now is (...) (27 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
|
| |
| | How to get digital outputs from the handyboard???...???
|
|
hi everyone, i have been trying for the past few days to get digital outputs from the board but with no success. i have been trying to get digitals outputs from the SPI's pins (J6). i have poke to make the port as output port. but the problem now is (...) (27 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
|
