|
|
 | | spo256 -Reply
|
| I bought both from B.G. Micro. (They were not selling the 3.12MHz crystal, however, I successfully used a slightly faster (3.26??) clock. I assume the pitch of the voice was a little higher but it worked. -Drew (...) Does anyone know who sell's the (...) (27 years ago, 7-Dec-98, to lugnet.robotics.handyboard)
| | | | | Re: spo256
|
| www.bgmicro.com about $5 or so for the chip ??? (27 years ago, 7-Dec-98, to lugnet.robotics.handyboard)
| | | | | re: www."hc11"
|
| wsomebody sent a list of www.'s from different source code for HC11 by mistake I erased please release then again thankx (27 years ago, 7-Dec-98, to lugnet.robotics.handyboard)
| | | | | communication problem
|
| Hi everybody I seek someone who can help me. I use handy board and xc40 board(it mounts xc4010 FPGA chip). And I have to make two board communicate each other. But there is a problem that I don't know the method. In handy board's F&Q page, It says (...) (27 years ago, 7-Dec-98, to lugnet.robotics.handyboard)
| | | | | Re: Extra output for clocking (Using Hardware Output Compare)
|
| Hugo: I am not going to be able to answer this one fully. We will need to hear from others on the list to hear how to mix assembler code into an IC program, how to have the IC program modify assembler variables, and how to set up interrupt service (...) (27 years ago, 7-Dec-98, to lugnet.robotics.handyboard)
|
|
