 | | Manual reading
|
|
Hi, Besides the source of manual on Interactive C from the internet, Is there any other sources on the IC software for me to find out more on IC , Eg book ? There are a lot of text book concern the software like C++, java , how about Interactive C . (...) (28 years ago, 12-Sep-98, to lugnet.robotics.handyboard)
|
| |
| | WARNING: +5 supply exposed
|
|
Take a moment to look at your Handy Board. There is a thick trace along the top, right and bottom edge. This is your regulated +5 line. Now look very closely at the outer edge of this trace. It should be completely green (covered with solder mask). (...) (28 years ago, 12-Sep-98, to lugnet.robotics.handyboard)
|
| |
| | WARNING: +5 supply exposed
|
|
Take a moment to look at your Handy Board. There is a thick trace along the top, right and bottom edge. This is your regulated +5 line. Now look very closely at the outer edge of this trace. It should be completely green (covered with solder mask). (...) (28 years ago, 12-Sep-98, to lugnet.robotics.handyboard)
|
| |
| | My problems with digital outputs
|
|
Dear Mr Fred Martin, My project requires digital outputs and does not need to have motor outputs. I have also read your FAQ and one of them states that by adding a hc374 IC chip in a similar fashoin to the one driving the motor circuits, and (...) (28 years ago, 12-Sep-98, to lugnet.robotics.handyboard)
|
| |
| | Re: analog problems
|
|
Dear Sam, It is so strange as you already replace all the chips. The "testanalogs()" is used to test A/D feature and analog port of MC68HC11. It will prompt you "Press START to test knob..." You then press START button and the reading of A/D port (...) (28 years ago, 12-Sep-98, to lugnet.robotics.handyboard)
|
