|
| | ELMO
|
| Hello all, From December 1997 until now I've been working on my Master's project. It consisted of a theoretical part and a practical part. In the practical part I made a little mobile robot using a Handy Board. In the next couple of weeks I will be (...) (26 years ago, 27-Jul-98, to lugnet.robotics.handyboard)
| | | | 68hc11F1
|
| Hello all, Thanks for all the replies that you have send. My board is now working, at 16 mhz with flash and ram. Richard (26 years ago, 27-Jul-98, to lugnet.robotics.handyboard)
| | | | RE: fischertechnik
|
| First of all, the HandyBoard works fine with fischertechnik. I've been using fischertechnik for a variety of purposes since about 1980. I've also used Lego Technic, although less extensively, for ten years or so. Size/Scale: If you build identically (...) (26 years ago, 27-Jul-98, to lugnet.robotics.handyboard)
| | | | Re: troubleshooting
|
| In your message you said: (...) good.... (...) yes, this is normal -- before you load pcode_hb.s19, the LCD is just as you describe. (...) d (...) I'm not clear the problem. if you enable "ignore feedback", does it then download properly? if so, (...) (26 years ago, 27-Jul-98, to lugnet.robotics.handyboard)
| | | | troubleshooting
|
| I have a problem assembleing my hanyboard. I am at the stage where i am doing the digital input circuit. Before this I successfully loaded pcode_hb.s19 into the handyboard and the interactive C message appeared. However, before i loaded pcode_hb.s19 (...) (26 years ago, 27-Jul-98, to lugnet.robotics.handyboard)
| |