|
|
 | | Multi-tasking under IC (Freeware version)
|
| I am somewhat new to handyboards and IC, so bear with me if this issue has been dealt with before. (I did check the FAQ and "some" of this list's archives prior to posting.) Under IC (the freeware version) cooperating processes communicate using (...) (26 years ago, 11-Jun-98, to lugnet.robotics.handyboard)
| | | | | Re: motor selection
|
| (...) From the archive: Date: Tue, 3 Mar 1998 17:12:30 -0500 (EST) (...) I have a sonar mounted on a panning servo, and I just bought an el-cheapo Cirrus CS-50. (It is functionally equivalent to a JR/Hitec JR-507 or HS-300). It works fine, although (...) (26 years ago, 11-Jun-98, to lugnet.robotics.handyboard)
| | | | | RE: input impedance
|
| Never mind, I have managed to solve the problem by cutting the trace between the 47k pull-up resistor and the sensor input. -----Original Message----- From: Joe Martin [SMTP:joema@mpx.com.au] Sent: Wednesday, 10 June 1998 18:29 To: (...) (26 years ago, 11-Jun-98, to lugnet.robotics.handyboard)
| | | | | D/A converter
|
| "Hi", from Hector Noriega, I am trying to send a data byte from port C out to a D/A converter faster than 1KHZ (target about 10KHZ) . I wrote a test subroutine in assembly code but I can not enable the address decoder using port B for the msb and (...) (26 years ago, 11-Jun-98, to lugnet.robotics.handyboard)
| | | | | onboard IR receiver
|
| the problem that i was having with the onboard IR receiver is that the codes that i retrieved from the ir_data() function were inconsistant from the same remote control button. the error was usually manifested in multiples of two, which lead me to (...) (26 years ago, 11-Jun-98, to lugnet.robotics.handyboard)
|
|
