 | | whoops, wrong test program
|
| Attached to this message is the test program and S19 file for the LCD code. --Chuck (28 years ago, 3-May-98, to lugnet.robotics.handyboard)
| | | | | My LCD driver
|
| Attached to this message is the LCD driver I wrote for the Handyboard written using ICC11. Feel free to use it. Some notes on it: The driver is designed to operate asynchronously. This is because the LCD can take several milliseconds to complete its (...) (28 years ago, 3-May-98, to lugnet.robotics.handyboard)
| | | | | Controlling a DC motor 2
|
| Hi again, I think i should change my previous question to the following. Is there any alternatives to control a DC motor motion (speed, direction etc) without using a motor driver? how? please explain briefly. Thank you for your replies. (28 years ago, 3-May-98, to lugnet.robotics.handyboard)
| | | | | Handy Board problem
|
| I was wondering if anyone knows where I could purchase the Sharp Is1U60 IR detector. I have looked for it, however none of the distributors I have checked with even carry it. I tried Digikey, Mouser Electronics, JDR, Jameco, BG Micro, and others. (...) (28 years ago, 3-May-98, to lugnet.robotics.handyboard)
| | | | | MODB - How Is Expanded Mode Entered
|
| If MODB pin is always grounded, how does the MCU get into expanded mode to access the 32K SRAM? The data sheet shows MODB HIGH to enter expanded mode. It show MODB LOW to enter single chip mode. What am I missing? -- ---...--- ipscone@halcyon.com (...) (28 years ago, 2-May-98, to lugnet.robotics.handyboard)
|
|
