|
|
 | | ? Mabuchi RS280 motor
|
| Hello all, I've connected a mabuchi rs280 motor to the handyboard. When activated with the following command, "motor(0,12);" the motor speeds up and then stops, and the board also beeps. the ratings for the motor are as follows voltage range 6-9 (...) (27 years ago, 16-Mar-98, to lugnet.robotics.handyboard)
| | | | | RE: IC Pointer Questions
|
| Hi, thanks for your reply ... Why don't I use the encoder0_counts variable ? I want to create a multi-tasked environment with seperate processes for each wheel to calculate wheel speeds. The same code will be used to calculate speed for 4 wheels. (...) (27 years ago, 15-Mar-98, to lugnet.robotics.handyboard)
| | | | | Re: IC Pointer Questions
|
| (...) If I am understanding you right... I haven't looked at the encoder routines yet, but I am assuming encoder0_counts is global. Why not, just omit the pointer count from the _encoder struct and just use the global, since you already have it? (...) (27 years ago, 15-Mar-98, to lugnet.robotics.handyboard)
| | | | | Gear Motors
|
| I was wondering if anyone has a good source for fairly high quality, low cost gear motors that inteface well with the handy board. Right now i am using a cheap little, current hungry 3v toy bulldozer as a platform. I would love to find some nice (...) (27 years ago, 15-Mar-98, to lugnet.robotics.handyboard)
| | | | | IC Pointer Questions
|
| Howdy all, I finally attached an infrared reflectance sensor to my handyboard and it works! With my non-existent electronic experiences I managed to solder a resistance (330 ohms) to a three-legged sensor similar to the four-legged variant mentioned (...) (27 years ago, 15-Mar-98, to lugnet.robotics.handyboard)
|
|
