 | | replacement components
|
|
hello all, I was wondering what kind of fuse i can use instead of the Polyswitch fuse and also will a darlington with close chartisics as the ztx614 work, as there are none in New Zealand. thankyou Brennan Mair gysmo@es.co.nz (27 years ago, 27-Jan-98, to lugnet.robotics.handyboard)
|
| |
| | Re: Simple Assembler Programs
|
|
Try this url for a test program. (URL) have not tried the program myself, so I can't tell you anything about it. (...) ___...___ ___...___ Jonathan Swaby 305 Sparks Bldg Computer Support Specialist 814-865-0693 Penn State University (...) (27 years ago, 26-Jan-98, to lugnet.robotics.handyboard)
|
| |
| | Simple Assembler Programs
|
|
Hello! Does anyone have some simple assembler programs that can be used to test the operation of the handyboard? For example, an assembler program that beeps the piezzo "speaker", or one that blinks some of the LEDs. Anything would be most helpful (...) (27 years ago, 26-Jan-98, to lugnet.robotics.handyboard)
|
| |
| | SPI routine for EEPROM
|
|
Application note on hooking up a EEPROM to the Finger Board SPI port. EAS-AN001 This also applies to the Handy Board SPI port. Very useful for datalogging and data table lookups without having to use up core memory. Embedded Acquisition Systems 1565 (...) (27 years ago, 26-Jan-98, to lugnet.robotics.handyboard)
|
| |
| | My servo controller article
|
|
I've updated it with the figure showing the state diagram. I apologize for the wide distribution but I've lost the email of the folks who wanted to see that figure. The updated article is at (URL) (27 years ago, 25-Jan-98, to lugnet.robotics.handyboard)
|
