 | | motor routines in lib_hb.c
|
|
Does anyone know why these eight speeds were chosen in lib_hb.c for the motors and what would happen if the code were re-written to allow any speed between 0 and 255? int _speed_table[]= { 0b00000000, /* speed 0 */ 0b00010001, 0b01001001, (...) (27 years ago, 14-Apr-97, to lugnet.robotics.handyboard)
|
| |
| | Re: NOTE 04/10/97 10:50:15
|
|
OK, I haven't looked at encoders.asm but if the following doesn't help just send more questions. (...) Sounds about right. (...) TCTL2 sets rising, falling, or both edge modes; TMSK1 arms interupts; IC event sets the TFLG1 register. (...) correct (...) (27 years ago, 14-Apr-97, to lugnet.robotics.handyboard)
|
| |
| | QFP sockets
|
|
Hi, Thanks for the response on finding a microcontroller. I have 1 little problem left: if I'm going to use a Motorola 68F333 or the somewhat cheaper 68HC916Y1 I need a conververter from 160-lead QFP (.65 pitch) to an "normal" pinout where I can (...) (27 years ago, 14-Apr-97, to lugnet.robotics.handyboard)
|
| |
| | RE: HB books
|
|
Mark Robillard has written 2 good books on robotics. No one has mentioned these books here before, so I though I would list them. Here are the 2 book titles : * Microprocessor controlled robotics * Advanced microprocessor controlled robotics These (...) (27 years ago, 14-Apr-97, to lugnet.robotics.handyboard)
|
| |
| | Re: sencdr0.asm
|
|
Yes, but why? Is the contents at ADCTL+X supposed to change? ---...--- ericson mar Master of Engineering Candidate Project: Mobile Robotics mar@cooper.edu (212)353-4356 Department of Mechanical Engineering The Cooper Union for the Advancement of (...) (27 years ago, 13-Apr-97, to lugnet.robotics.handyboard)
|
