|
|
 | | LCD display
|
| Hi, Is there any way to disable the LCD display? Rather the heartbeat. I'm not using the LCD, and I don't want anything printing the the LCD, heartbeat included. Thanks, Maria ---...--- Maria Pirsic IEEE Branch Treasurer 96/97 Carleton University (...) (28 years ago, 28-Feb-97, to lugnet.robotics.handyboard)
| | | | | Re: timing
|
| (...) Mike, Not enough info to determine your problem. Are you using the Output Compare functions, or are you trying to emulate that functionality some way? The OC lines are hardware-set, so they go off whenever the free-running counter matches some (...) (28 years ago, 27-Feb-97, to lugnet.robotics.handyboard)
| | | | | timing
|
| Hi- I'm attempting to write an assembly routine to control a pulse width, but I can't seem to get the timing down. For example, I can output a 3.33ms pulse width, but if I run the routine again, it sometimes jumps to 3.5ms, and then jumps back down (...) (28 years ago, 27-Feb-97, to lugnet.robotics.handyboard)
| | | | | Re: IR collision avoidance
|
| (...) Good question! We had a lot of noise problems and learning curve stumbles along the way. Our first bad news was that we had a range of a few inches. We finally beat that one fooling with frequencies, caps, etc. and then found out our range was (...) (28 years ago, 27-Feb-97, to lugnet.robotics.handyboard)
| | | | | Re: IR collision avoidance
|
| (...) ** My only question is how do you keep the bot at a constant 18 inches ** away from the wall with a collision detection algorithm? Is it ** possible to get analog outputs from a sensor indicating the ** distance from a wall? Or is there is (...) (28 years ago, 27-Feb-97, to lugnet.robotics.handyboard)
|
|
