Subject:
|
Re: Are these Robolab parts?
|
Newsgroups:
|
lugnet.robotics.edu
|
Date:
|
Tue, 5 Mar 2002 05:42:48 GMT
|
Viewed:
|
4958 times
|
| |
|
|
Jan-Albert van Ree wrote:
>
> Hope this is the correct newsgroup...
>
> The URL below is a picture in which some kind of sensor is displayed...
> The brick is 2*3 studs, and 1 1/3 brick high. The big hole in the side is
> big enough for a Technic axle to go through. The small hole seems to be a
> sensor opening, on top the holes are made for a 4.5v connector.
>
> http://www.vanree.net/images/dacta_sensor.jpg
Hey, that's a nifty looking shaft encoder. Where did you dig up that
thing from? Is it truly made by TLC? It looks like one of those
handcrafted works by John Barnes.
It's the basis for an angle or rotation sensor. You will need to use it
with a light sensor. You can find info on using such a shaft encoder in
Ben Erwin's "Creative Projects with LEGO Mindstorms" book.
--
C S Soh
CSSoh's Lego Pneumatics
http://www.geocities.com/cssoh1
... where air is power!
|
|
Message is in Reply To:
 | | Are these Robolab parts?
|
| Hope this is the correct newsgroup... The URL below is a picture in which some kind of sensor is displayed... The brick is 2*3 studs, and 1 1/3 brick high. The big hole in the side is big enough for a Technic axle to go through. The small hole seems (...) (23 years ago, 3-Mar-02, to lugnet.robotics.edu)
|
4 Messages in This Thread:
 
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
