 | | Control Cybermaster from RCX with feedback —Morten Høgholm Pedersen
|
| | | Is it possible to interface a cybermaster and an RCX without the use of a PC, also without using up all sensor and motor ports? Sincerely, Morten H Pedersen (20 years ago, 10-Jun-04, to lugnet.robotics.cybermaster, lugnet.robotics.rcx)
|
| | | |
| | | | | Re: Control Cybermaster from RCX with feedback —Danny Staple
|
| | | | (...) It might be theoretically possible to use one RCX sensor port for control of the cybermaster - and using the one motor and one sensor port on the cybermaster. A few multiplexing designs I've seen use switching between passive and active sensor (...) (20 years ago, 10-Jun-04, to lugnet.robotics.cybermaster, lugnet.robotics.rcx)
|
| | | | |
| | | | | | Re: Control Cybermaster from RCX with feedback —Morten Høgholm Pedersen
|
| | | | | (...) Yes, I also hoped for some ready made NQC library e.g., since I saw someone was working on that once (around 2001 in one of these newsgroups) Morten (20 years ago, 11-Jun-04, to lugnet.robotics.cybermaster, lugnet.robotics.rcx)
|
| | | | | |
| | | | | | Re: Control Cybermaster from RCX with feedback —Sandy Johnson
|
| | | | (...) This might be old news, but I just tried it anyway... You can connect an RCX motor port to a CyberMaster sensor port and vice versa and get tri-state info. You can distinguish between the motor floating, off, and one of forward or reverse (...) (20 years ago, 11-Jun-04, to lugnet.robotics.cybermaster, lugnet.robotics.rcx)
|
| | | | |
| | | | | | Re: Control Cybermaster from RCX with feedback —Mark Bellis
|
| | | | (...) I think it's theoretically possible to communicate an 8 state signal from the RCX to the Cybermaster's passive sensor port. The passive sensor port measures resistance as well as using a switch - the 3 switches in the cybermaster set have (...) (20 years ago, 11-Jun-04, to lugnet.robotics.cybermaster, lugnet.robotics.rcx)
|
| | | | |
