To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 9963
9962  |  9964
Subject: 
Re: Micro Scout programming with VLL bar code: HOWTO
Newsgroups: 
lugnet.robotics
Date: 
Tue, 11 Jan 2000 21:03:40 GMT
Viewed: 
3386 times
  
In lugnet.robotics, Russell Nelson <nelson@crynwr.com> writes:
Richard Earley writes:

Have you tried using the computer monitor? ie: display the bar code on your
computer screen and scan along the code? this may make a simple scout/code
pilot programmer possible.

Even better, flash a big square in the same pattern as a bar code.
Hold the Micro-Scout up to the screen.

--
-russ nelson <sig@russnelson.com>  http://russnelson.com
Crynwr sells support for free software  | PGPok | "Ask not what your country
521 Pleasant Valley Rd. | +1 315 268 1925 voice | can force other people to
Potsdam, NY 13676-3213  | +1 315 268 9201 FAX   | do for you..."  -Perry M.

But that requires timing on the part of the computer. A simple display of a bar
code could also be posted to a web page for access by all....

-Rich



Message has 3 Replies:
  Re: Micro Scout programming with VLL bar code: HOWTO
 
(...) Couldn't you use an animated gif? (25 years ago, 11-Jan-00, to lugnet.robotics)
  Re: Micro Scout programming with VLL bar code: HOWTO
 
Richard Earley writes: > But that requires timing on the part of the computer. A simple display of a bar > code could also be posted to a web page for access by all.... Relative timing is all that's needed. All you need is a wait() routine which (...) (25 years ago, 11-Jan-00, to lugnet.robotics)
  Re: Micro Scout programming with VLL bar code: HOWTO
 
Perhaps an animated GIF file consisting of a black or white square that alternate where the timing is specified in the GIF file and executed by the computer. This would still be able to be posted on web sites. Brian (...) -- ___...___ Brian Johnson (...) (25 years ago, 11-Jan-00, to lugnet.robotics)

Message is in Reply To:
  Re: Micro Scout programming with VLL bar code: HOWTO
 
Richard Earley writes: > > Have you tried using the computer monitor? ie: display the bar code on your > computer screen and scan along the code? this may make a simple scout/code > pilot programmer possible. Even better, flash a big square in the (...) (25 years ago, 11-Jan-00, to lugnet.robotics)

10 Messages in This Thread:




Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    
Active threads in Robotics

 
Contact Recovery Nerd for Speedy USDT / BTC Recovery
22 hours ago
Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR