To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 796 (+5)
  RE: Worm Drive Question
 
I don't think you'll be able to mimic a real elevator with an RCX. There just aren't enough inputs. You'll need some sort of sensor on the car to tell it when it is lined up with a floor. You'll need a pair of sensors on each floor to request an up (...) (28 years ago, 26-Nov-98, to lugnet.robotics)
 
  Wire set length
 
(...) The length is in cm. The long ones are a bit too much. I would like to get more of the short or med. ones, but I guess if I was building a 10 story elevator the long ones might be good. I also got the turn table (Pack of 2) great part. I am (...) (28 years ago, 25-Nov-98, to lugnet.robotics)
 
  Re: Surveillance Robot
 
(...) I can confirm that I made up that rumor. It might be true, and there's certainly some supporting evidence, but for $50 I'm not too hopeful. (28 years ago, 25-Nov-98, to lugnet.robotics)
 
  Re: Worm Drive Question
 
(...) You can do WAY better than that, and without *cheating* by using a (non-LEGO!) paper strip. The light sensor can reliably distinguish the *colours* of smooth plates. One of the standard exercises for the Dacta control lab is to make a barcode (...) (28 years ago, 25-Nov-98, to lugnet.robotics)
 
  Re: legOS
 
(...) Er? Since when you rewrite the firmware, you can take full control of the i/o pins of the H8, it seems perfectly possible to me to drive inputs as outputs and fry something you didn't mean to fry... You have to be careful to make sure you (...) (28 years ago, 26-Nov-98, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR