Subject:
|
NQC (Mac) and KeySpan card?
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Tue, 10 Aug 1999 02:07:49 GMT
|
Original-From:
|
Michael Griffith <WEBMASTER@KVOAstopspam.COM>
|
Viewed:
|
546 times
|
| |
|
|
Since I have a bunch of stuff that plugs into a serial port on my Mac, I
purchased the KeySpan expansion card that adds four more ports.
I just downloaded NQC and know that you can change ports with 'nqc -e
RCX_PORT b' (I am doing this from memory, so the -e might be wrong).
Does anyone know if I can address one of the add-on ports rather than
the built-in modem or printer port?
Thanks!
Mike
==========================================
Michael Griffith KVOA TV - Tucson
webmaster@kvoa.com http://kvoa.com/
Direct: 520-884-4661 Fax: 520-628-7186
==========================================
--
Did you check the web site first?: http://www.crynwr.com/lego-robotics
|
|
Message has 1 Reply:
 | | Re: NQC (Mac) and KeySpan card?
|
| (...) Yes, but you need to know the name of the device driver, and this is usually pretty difficult to find. Serial ports use two separate drivers - one for input and one for output. Usually the names are something like this: ".xxxIn" and ".xxxOut" (...) (25 years ago, 11-Aug-99, to lugnet.robotics)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
