To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 4936 (+5)
  Re: Some comments (long)
 
(...) Thanks, I think I understand how it works. John A. Tamplin Traveller Information Services jat@LiveOnTheNet.COM 2104 West Ferry Way 256/705-7007 - FAX 256/705-7100 Huntsville, AL 35801 -- Did you check the web site first?: (URL) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: Some comments (long) (was: Something else is needed, I think...)
 
Kekoa Proudfoot wrote in message ... (...) Do you think it would be possible with improved firmware to support inline H8 code embedded in a user program? For example, a special byte code could indicate that the following code should be executed (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: Some more comments and suggestions.
 
Well, now that you mention it... lugnet.robotics.rcx.misc might be the best way to go. That seems to have the most consistency with existing groups. If that group's discussion splinters considerably, then new groups could be created in the l.r.r.* (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: Some comments (long) (was: Something else is needed, I think...)
 
(...) Good idea! I like it! The only problem I can see with this is I'm not sure if the H8 supports position independant code or not. If it does, then there's no problem. (...) (28 years ago, 6-May-99, to lugnet.robotics)
 
  Re: Some comments (long) (was: Something else is needed, I think...)
 
(...) You might be able to do this if you were clever about it; you might be able to define an opcode that defines a native subroutine that you can call with another opcode, say, that passes in 16- or 32-bit values in registers and expects you store (...) (28 years ago, 7-May-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR