 | | Re: Angle Sensor; 1999 Catalog —Carlson, Doug R (MN65)
| | | | (...) I am using two angle sensors in my synchro drive bot and both are rotating at mini motor full speed. There have been times where it seemed to drop a few counts ( approx. 1% ) but I have yet to verify this. I only noticed this because after (...) (26 years ago, 5-Feb-99, to lugnet.robotics)
| | | | | | | | | | Angles and Diagonal Lines (was: Re: Angle Sensor) —Jeff Elliott
| | | | | (...) I run a plotter with two lightly loaded 'old' 9v motors. At power level 4, the angle sensors dropped readings. I geared the sensors down 3:1, and they seem to work fine now. The newer 9v motors are slower - your results may vary. (BTW: the (...) (26 years ago, 5-Feb-99, to lugnet.robotics)
| | | | | | |
