 | | Re: need to make a 15 degree angle —Nick Kappatos
| | | | (...) Further measurements show that connector #3 is 22.5 degrees - this means you can use these to make a jointed 90 degree arc with 5 panels (the ends would be perpendicular to each other). Would this meet your design requirement? (16 years ago, 2-Oct-08, to lugnet.robotics)
| | | | | | | | | | Re: need to make a 15 degree angle —Sam Pagel
| | | | | (...) The arc in question only covers 75degrees (5 panels, the first starting at a 15 degree angle). i managed to make it effectively with the suggestion of triangles out of technic pieces. triangles made of two 1X6 technic bricks and one 1X2 brick (...) (16 years ago, 2-Oct-08, to lugnet.robotics)
| | | | | | |
