 | | GBC display in Fana'Briques, June 28-29 - call for participants
|
|
Hello GBC enthousiasts and others, During the Fana'Briques event in Rosheim (France), we'll try to get use of the extra space we have for the GBC to make it as big as we can! Our ambitious aim is to reach 100 of modules,last year we had 29 but there (...) (17 years ago, 17-Apr-08, to lugnet.events, lugnet.robotics, lugnet.technic, FTX) !
|
| |
| | Re: NXC: turning on the light
|
|
(...) Well... my messages were published about 10 hours after posting... :-( Philo (17 years ago, 16-Apr-08, to lugnet.robotics)
|
| |
| | Re: NXC: turning on the light
|
|
(...) Philo wasn't able to post here but via email he pointed out that it is best to use the lamp on an output port rather than a sensor port. Here's what he had to say: Since the lamp is a rather power hungry device, it is best to drive it with an (...) (17 years ago, 15-Apr-08, to lugnet.robotics)
|
| |
| | Re: NXC: turning on the light
|
|
We successfully tried the following: task light() { OnFwd(OUT_A, 100); } It works like a motor =) OnRev works as well. We haven't yet tried the other idea. (17 years ago, 15-Apr-08, to lugnet.robotics)
|
| |
| | Re: NXC: turning on the light
|
|
(...) Hi, Have you tried to connect the adapter cable in the output port and put the lamp on it? Use this program to test: task main() { OnFwd(OUT_A, 100); Wait(5000); Off(OUT_A); } This program assumes that you connected the cable in output A. (...) (17 years ago, 15-Apr-08, to lugnet.robotics)
|
