 | | Electromagnetic device —Patrick J. Levy
|
| | | Hi, I was wondering if it is possible to use a electromagnetic device with the RCX and NXT. I tried with this one from a disk drive, and it worked quite well, but a few seconds after it start, the RCX shows the "low battery" icon. (The batteries are (...) (18 years ago, 15-Jan-07, to lugnet.robotics)
|
| | | |
| | | | | Re: Electromagnetic device —Chris Phillips
|
| | | | | (...) supply. You might want to measure the coil resistance to see what kind of current it is trying to draw from your RCX. I do notice from your picture that you have a version 1.0 RCX equipped with an AC power input jack. Have you tried running (...) (18 years ago, 15-Jan-07, to lugnet.robotics.nxt, FTX)
|
| | | | | |
| | | | | Re: Electromagnetic device —Geoffrey Hyde
|
| | | | | "Patrick Levy" <patrick@omiccron.com.br> wrote in message news:JBxJ1I.En@lugnet.com... (...) when you use an electromagnet with the RCX. You didn't post the technical specifications of the electromagnet you have wired up to the sensors, did it have (...) (18 years ago, 16-Jan-07, to lugnet.robotics.nxt)
|
| | | | | |
| | | | | | | Re: Electromagnetic device —Dave Curtis
|
| | | | | | (...) I would add that it will take some experimenting to get the parameters correct. Pick your operating conditions (parallel outputs, or no, etc...) and then given the supply voltage and maximum current allowance, you know the coil resistance you (...) (18 years ago, 16-Jan-07, to lugnet.robotics.nxt)
|
| | | | | | |
| | | | | Re: Electromagnetic device —Jon Gilchrist
|
| | | | Yes, you can use an electromagnet with the RCX. Depends on what you want to do with it, but it should work. The device from a disk drive might be a 12 volt device, or 5. The RCX puts out around 8-9, so either way the device isn't drawing the correct (...) (18 years ago, 16-Jan-07, to lugnet.robotics.nxt)
|
| | | | |
| | | | | | Re: Electromagnetic device —Patrick J. Levy
|
| | | | Thanks everybody for the explanations! Everything start to make sense now. I understand that a resitor will limit only voltage across the circuit, but not current, this is very clear also. So, i will look for a small electromagnet, (9 volts) because (...) (18 years ago, 16-Jan-07, to lugnet.robotics.nxt, lugnet.robotics)
|
| | | | |
