 | | Re: Request for info on the Control Lab Interface. —Rob Doucette
| | | | (...) Yes, programs are executed on the PC. (...) Nothing is stored on the device. (...) It resides on the PC. (...) AFAIK, you will need a newer version of ROBOLAB. The older versions (forget which) did not support ControlLab. If you're up to the (...) (19 years ago, 11-Apr-06, to lugnet.robotics, lugnet.technic, FTX)
| | | | | | | | | | Re: Request for info on the Control Lab Interface. —Jordan Bradford
| | | | | (...) Thanks for your information! I was also sent via email a very helpful page: (URL) His (URL) Research Page> has source code, which was also helpful. In fact, his ActiveX control might be useful for NQC. I had trouble getting it to connect to my (...) (19 years ago, 12-Apr-06, to lugnet.robotics, lugnet.technic, FTX)
| | | | | | | | | | | | Re: Request for info on the Control Lab Interface. —Jordan Bradford
| | | | | (...) Another question: Does this device work with serial port to USB adapters? I'd like to make this code as robust as possible, so this would be nice to know. If so, then I'd need to know if those adapters map themselves to the equivalent of COM1, (...) (19 years ago, 14-Apr-06, to lugnet.robotics, lugnet.technic, FTX)
| | | | | | |
