 | | Re: A LEGO double-throw switch?
|
|
(...) Since turning the 9V wire connectors 90 degrees reverse the polarity, can't you play with how the wires are connected to the switches to re-reverse the polarity on one wire? (...) -Kyle (21 years ago, 22-Aug-05, to lugnet.robotics)
|
| |
 | | Re: Tripping a relay.
|
|
If you hit a 5v latching relay with 9v, will it damage it? (21 years ago, 22-Aug-05, to lugnet.robotics)
|
| |
 | | Re: A LEGO double-throw switch?
|
|
(...) Ok, Here's a partial solution (assuming you don't want to mechanically link the ends together). Given: Polarity Switch 1 - rotated forward by Forklift Polarity Switch 2 - rotated forward by crate when it arrives at the end Motor - located by (...) (21 years ago, 22-Aug-05, to lugnet.robotics)
|
| |
 | | Re: A LEGO double-throw switch?
|
|
(...) No, I think you should use one polarity switch, without handle to greatly reduce the friction needed to throw it. Putting the crate on the conveyor throws the switch, and when the crate gets to the other end it could push a lever, or better (...) (21 years ago, 22-Aug-05, to lugnet.robotics)
|
| |
 | | Re: A LEGO double-throw switch?
|
|
(...) Hi Brian, How will the package arriving at the other end "throw a switch?". Is there enough friction between the package and the belt? Will there be a mechanism in the belt itself to "go halfway and stop"? If you only used one polarity switch, (...) (21 years ago, 22-Aug-05, to lugnet.robotics)
|