 | | Re: Light seeker
|
|
Ahh- you missed something. In the seek task, I am altering an absolute position, not a relative or error code. It is then in the other task that I compare the position with the actual position and generate the error value. Your fix would set the (...) (22 years ago, 14-Dec-04, to lugnet.robotics)
|
| |
 | | rcx controlling software
|
|
i want to use an RCX (and sensors, of course) to control software running in my computer: sending sensor data (probably light sensor) to the computer to control parameters in an audio software like Pure Data or Max/MSP. How should i proceed? Is (...) (22 years ago, 14-Dec-04, to lugnet.robotics)
|
| |
 | | Re: input used as output
|
|
(...) Have a look at the book "The Unofficial Guide to LEGO Mindstorms" from Knudsen / Noga published by O'Reilly. ( there may be other sources, but that is mine ) My book is translated to german (and published in the year 2000) so the following is (...) (22 years ago, 13-Dec-04, to lugnet.robotics)
|
| |
 | | Question about Lego Mindstorms Infrared Protocol.
|
|
Hello, From (URL) site I got the description of the RCX infrared protocol. Now I tried to send the opcode for a double beep, I calculated the following: Opcode: 5901 (beep beep) binary = 01010101 11111111 00000000 01011001 10100110 00000001 (...) (22 years ago, 13-Dec-04, to lugnet.robotics)
|
| |
 | | Re: Replacement Firmware Released
|
|
(...) Dick, congrats for the incredible job, a real paradigm-shift for most mindstorms programmers. Mario (22 years ago, 13-Dec-04, to lugnet.robotics)
|
| |
 | | Re: Why NQC over Robolab?
|
|
(...) I suspected as much. (...) Well crud. Now I'm going to have to go out and get one of those things. (...) Suffice to say, Robolab does not currently support the Spybot. Sounds like an interesting project though.... Tom (22 years ago, 13-Dec-04, to lugnet.robotics)
|
| |
 | | Re: Replacement Firmware Released
|
|
(...) Congrats again on the significant 'smart stuff'! Your feedback on the sensor bugs did the fix at the right time too. This firmware obsoletes a lot of Robolab and other RCX approaches, and analog interfacing ... What am I talking about? Motors (...) (22 years ago, 12-Dec-04, to lugnet.robotics)
|
| |
 | | Re: Ultimate ROBOLAB
|
|
(...) Yes and no! In fact, the name Ultimate ROBOLAB was chosen together with the father of ROBOLAB Prof Chris Rogers. This might be a bit confusing as to compatibility. But compatibility there is: 1. Most of the "modifiers" like "Red (...) (22 years ago, 12-Dec-04, to lugnet.robotics)
|
| |
 | | Re: Ultimate ROBOLAB
|
|
(...) I think Ultimate Robolab sounds very cool. Unfortunately, I think some Robolab users may be confused by the name and think that their Robolab programs will be completely reuseable in Ultimate Robolab. As far as I can figure this is simply not (...) (22 years ago, 12-Dec-04, to lugnet.robotics)
|
| |
 | | Re: Why NQC over Robolab?
|
|
(...) Then I would like to announce that NQC supports the MicroScout and CodePilot bricks. It has had this support for several years. (...) The Spybot is a fully programmable lego brick like the RCX and Scout. Like the Scout its firmware is in ROM. (...) (22 years ago, 12-Dec-04, to lugnet.robotics)
|