| | Re: RCX 2.0 Power Supply
|
| (...) On a marginally related note, does someone out there have the equipment to accurately test the output voltage of some typical dc power supplies like the one used for this external ps? I tested every ps I could find in my house (probably 20 or (...) (20 years ago, 15-Sep-04, to lugnet.robotics, lugnet.trains)
| | | | Re: RCX 2.0 Power Supply
|
| (...) You need to check the voltage while the PS is under load. Pretty much every power supply puts out more when the load is low or nothing. Has to do with loads of factors, but mostly quality of the PS (and (thus) internal resistance of the PS) (...) (20 years ago, 15-Sep-04, to lugnet.robotics, lugnet.trains)
| | | | Re: RCX 2.0 Power Supply
|
| (...) It is nearly impossible to build a power supply that puts out the rated voltage when there is no load. Most will put out too high a voltage (like you have seen), some just shut down. To meassure the voltage of a PS, shorten it with a 1000 Ohm (...) (20 years ago, 15-Sep-04, to lugnet.robotics, lugnet.trains)
| | | | Re: RCX 2.0 Power Supply
|
| (...) Not nearly impossible. It just requires a little more intelligence be put into the power supply. All the regulated power supplies my company produces contain a circuit called a down programmer. This circuits job is to discharge the filter (...) (20 years ago, 16-Sep-04, to lugnet.robotics, lugnet.trains)
| | | | Re: RCX 2.0 Power Supply
|
| (...) Sure it can be done, but it is very uncommon. I seriously doubt that any wall-wart (even very good ones) do it. I have a very high quality wall-wart. It puts out 2A at 3 to 24V, is very stable at the whole range from very little to full load (...) (20 years ago, 16-Sep-04, to lugnet.robotics, lugnet.trains)
| |