|
In lugnet.robotics.spybotics, John Barnett wrote:
> Hi,
>
> I've been trying some experiments with Spybotic
> communications using Bricxcc and NQC.
>
> I have been able to send and receive messages
> using 'SendSpybotMessage()' and 'RxMessage()'
>
> However, when I try to read the controller, I am
> only able to register button 2 (the red one).
>
> The other buttons switch the motors as normal.
>
> Is there somthing I have to do in order to be able
> to read all the buttons?
I seem to remember in Mindscript, there is a way to disable the RC messages. I
think it was something like "setRCDisable"
I'm not sure if that is implemented in the latest verson of NQC. (and I'm not
sure if that's the right command) But I hope that gives you a place to start.
Steve
|
|
Message has 1 Reply:
Message is in Reply To:
| | Reading Spybotic controller
|
| Hi, I've been trying some experiments with Spybotic communications using Bricxcc and NQC. I have been able to send and receive messages using 'SendSpybotMessage()' and 'RxMessage()' However, when I try to read the controller, I am only able to (...) (21 years ago, 24-Jan-04, to lugnet.robotics.spybotics, lugnet.robotics)
|
3 Messages in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|