| |
In lugnet.technic, John Barnes writes:
> Ok, here is an extrapolated result for the short circuit (stalled) test.
>
> The current at 9 volts would be 3.6 amps...
Holy C..........
That's quite high (understatement) for a little LEGO motor. Do you think
it's possible that the train controller I used in my test didn't produce
enough juice? If that's the case, then the motor has a higher maximum stall
torque than I measured.
TJ
|
|
Message is in Reply To:
 | | Re: 8475 Motor Tests
|
| Ok, here is an extrapolated result for the short circuit (stalled) test. The current at 9 volts would be 3.6 amps. Since I did not wish to burn up the motor, I checked current readings at both 3 and 6 volts and also measured the DC resistance and (...) (22 years ago, 8-Jan-03, to lugnet.technic, lugnet.robotics)
|
10 Messages in This Thread:
  
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
