 | | RCX Voltage Question —Joshua Entz
|
| | | If you connect two motors to the same output port, will they each get 4.5 volts, or will it take current from the other outputs? (22 years ago, 1-Jan-03, to lugnet.robotics)
|
| | | |
| | | | | Re: RCX Voltage Question —Robert Fay
|
| | | | | Both motors will receive approximately 9 volts. This depends on the batteries you are using. -- Bob Fay (URL) <sailrpengn@suscom.net> wrote in message news:H81u10.AzE@lugnet.com... (...) (22 years ago, 1-Jan-03, to lugnet.robotics)
|
| | | | | |
| | | | | Re: RCX Voltage Question —Steve Baker
|
| | | | (...) When you connect two devices across a source of electricity, you can do so either in series or in parallel. In parallel: +---...---+---...---+ | | | | | | Battery Motor Motor | | | | | | +---...---+---...---+ In series: +---...---+ | | | Motor (...) (22 years ago, 1-Jan-03, to lugnet.robotics)
|
| | | | |
| | | | | | Re: RCX Voltage Question —Juergen Stuber
|
| | | | | (...) Actually the motor control chips in the RCX limit the current, which will limit the maximal power that can be drawn from a port. I don't know how many motors it takes (I'd guess one) to reach the limit, but from then on extra motors will not (...) (22 years ago, 2-Jan-03, to lugnet.robotics)
|
| | | | | |
| | | | | | Re: RCX Voltage Question —Mark Riley
|
| | | | "Steve Baker" <lego-robotics@crynwr.com> wrote in message news:3E1374CB.70000@...ail.net... (...) Just a minor quibble... The current for two identical resistive loads in series will be half that of just one of the loads when connected to the same (...) (22 years ago, 2-Jan-03, to lugnet.robotics)
|
| | | | |
