Subject:
|
RE: RCX Tank Base
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Wed, 4 Dec 2002 17:51:21 GMT
|
Original-From:
|
Rob Limbaugh <RLimbaugh@greenfieldgroup+saynotospam+.com>
|
Viewed:
|
2165 times
|
| |
|
|
<SNIP>
>
> I suppose tying individual plates to the tracks would work
> OK, but tying
> tens or hundreds of tight knots and keeping them small enough
> not to foul
> the grears would be tricky and tedious.
What I meant with the thread was to use the studs as channels for the thread and
tie them perpendicular to the shape of the conveyor piece, one thread on each
side.
[o|o#o|o] <--track piece, chain side, | = string, o = holes in conveyor link
[o&o o&o] <--track piece, conveyor side, & = knot in string, o = studs on 1x4
plate
I wouldn't do all the links if I didn't have to... Perhaps every 5th link and
then offset if using a multi-track setup, like this:
[o|o o|o][o o o o] [o|o o|o][o|o o|o]
[o o o o][o o o o] [o o o o][o o o o]
[o o o o][o|o o|o] [o o o o][o o o o]
[o o o o][o o o o] [o o o o][o o o o]
[o|o o|o][o o o o] or [o|o o|o][o|o o|o]
[o o o o][o o o o] [o o o o][o o o o]
[o o o o][o|o o|o] [o o o o][o o o o]
[o o o o][o o o o] [o o o o][o o o o]
[o|o o|o][o o o o] [o|o o|o][o|o o|o]
... or with 1x8's across multiple tracks... whatever suits the need, I'd
suppose.
Personally, I'll probably just buy a bunch of conveyor links and permanantly
glue 1x4 studded plates to the links and use them when I need to and call it a
day. I might even make some using 1x4 flat plates using glue.
- Rob
|
|
1 Message in This Thread:
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
