Subject:
|
Thinner Diff (was: something i said?)
|
Newsgroups:
|
lugnet.robotics, lugnet.technic
|
Date:
|
Sun, 20 Oct 2002 03:58:57 GMT
|
Viewed:
|
1670 times
|
| |
|
|
In lugnet.robotics, Mike Fusion writes:
> crossposted to lugnet. technic
>
>
> you will find a new page that has a new differential which has been made
> thinner and with a lot less gear lash.
After playing with your designs for a bit, I decided to see if I could make it
any thinner. I did, but it's a compromise: compared to your thindiff, I suspect
mine is looser, less sturdy, and more prone to binding. It is, however, only 5
studs total. I would still use yours unless I really had to have it smaller (or
I didn't have another 40t gear!).
It's here: http://www.brickshelf.com/cgi-bin/gallery.cgi?f=27110
|
|
Message has 1 Reply:
 | | Re: Thinner Diff (was: something i said?)
|
| you could make that one stud thinner by placing it within a framework. now i have something else to work on... i did recently make on from a 24t gear but it rotates around one of the four holes off axis and is really only good for use in a sensor (...) (22 years ago, 20-Oct-02, to lugnet.robotics, lugnet.technic)
|
Message is in Reply To:
| | something i said?
|
| crossposted to lugnet. technic just wondering if i did anything wrong, i posed a problem a while back and haven't gotten any responses.... but anyways, there is an update to my website: (URL) will find a new page that has a new differential which (...) (22 years ago, 13-Oct-02, to lugnet.robotics, lugnet.technic)
|
11 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
This Message and its Replies on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
Active threads in Robotics
|
|
|
|
|
|
