To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 1889
    Re: sensor input mux calculations —John A. Tamplin
   (...) Thanks, I didn't think of that. Since it is a linear function to convert the measured resistance to the switch values, this is much faster and also has better spacing between the values. Using 300, 600, 1.2k, 2.4k, and 4.8k ohm resistors, you (...) (26 years ago, 29-Dec-98, to lugnet.robotics)
   
        Re: sensor input mux calculations —Michael Gasperi
   The lego touch sensors are not simple on/off switches like you guys show. There is at least 500 ohms in series with them when they are closed. They also seem to be slightly touch sensitive. A light touch will read 1.5K while a hard push is close to (...) (26 years ago, 30-Dec-98, to lugnet.robotics)
 

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR