To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / 17932
17931  |  17933
Subject: 
Re: Powering motors from the mains
Newsgroups: 
lugnet.technic, lugnet.robotics
Date: 
Fri, 17 May 2002 13:39:08 GMT
Viewed: 
185 times
  
In lugnet.technic, Larry Pieniazek writes:
In lugnet.technic, Steven Lane writes:
I find batteries a pain, especially as there output isn't constant over
their lifetime, therefore I'd love to be able to power my motors from the
mains. I'd like to know what methods their are are doing this. I'd prefer a
purist option but I do know which end is the dangrous one on a soldering
iron. It also has to work in the UK, home of the three pin plug.

Purist approach is to use a 9V train speed reg and LEGO(r) wires from the
speed reg to your motor(s), possibly through the polarity reverser switch to
give control. The speed reg is powered from a wall wart trafo so if you buy
a UK train set or UK used speed reg (should not be too hard to come by) or
even pay LD's high price for a new one, you should be all set. The UK wall
wart will have the appropriate 3 pins for your funky mains points and will
be 220v compatible.

The wall wart from a speed reg can also power an RCX that has the power
connector (1.0 but not 1.5. I do not know if they put it back for 2.0 or
not) if you want to go that way...

4548s were 5ukp in Toysrus a while back

Someone in the UK has a UK 3 pin adaptor for $5

http://www.bricklink.com/store.asp?p=phillwright&itemID=504739

I'm sure you can find a UK person to trade a controller.

Mark



Message has 1 Reply:
  Re: Powering motors from the mains
 
In lugnet.technic, Mark Morgan writes:> (...) wanted to power, it is exactly what you need and no extra. Those 4548s turn up in the strangest places, though, so haunting old and poorly managed stores (TRU comes to mind, as Mark said!) that carried (...) (23 years ago, 17-May-02, to lugnet.technic, lugnet.robotics)

Message is in Reply To:
  Re: Powering motors from the mains
 
(...) Purist approach is to use a 9V train speed reg and LEGO(r) wires from the speed reg to your motor(s), possibly through the polarity reverser switch to give control. The speed reg is powered from a wall wart trafo so if you buy a UK train set (...) (23 years ago, 17-May-02, to lugnet.technic, lugnet.robotics)

15 Messages in This Thread:






Entire Thread on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact

This Message and its Replies on One Page:
Nested:  All | Brief | Compact | Dots
Linear:  All | Brief | Compact
    
Active threads in Robotics

 
Verified and Trusted Team of Hackers
9 hours ago
Custom Search

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR