Subject:
|
Vision Command
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Tue, 9 Oct 2001 11:40:02 GMT
|
Original-From:
|
Javier Taibo <JTAIBO@UDC.ESspamcake>
|
Reply-To:
|
[jtaibo@udc]spamless[.es]
|
Viewed:
|
455 times
|
| |
|
|
Hello all,
I'm thinking about buying the Vision Command, but I haven't seen any
reference to the use of the camera from Linux (NQC or even better LegOS).
Do you know if it is supported? I would like to hear from anyone who
has used the Vision Command with the RCX from Linux, with LegOS or NQC.
Any reference to information about this subject would be very appreciated.
Thanks in advance,
Javier Taibo <jtaibo@udc.es>
Visualization for Engineering Architecture and Urban Design Group
VideaLAB - University of Coruña
http://videalab.udc.es
|
|
Message has 2 Replies:
 | | Re: Vision Command
|
| (...) i think you won't get any response from anybody who has successfull used the vision command set with linux !?! AFAIK there is no such solution. As the vision command camera is a logitech camera in fact, you perhaps should ask logitech for (...) (23 years ago, 9-Oct-01, to lugnet.robotics)
| | | Re: Vision Command
|
| (...) It isn't AFAIK. From (URL) : There exists also a "LEGO-Cam" made by Logitech, using an VV6410 sensor (note the 36 pins!) by ST-VVL and the STV610 ASIC. The LEGO-Cam has also a microphone, a LED and a button built-in. This camera is not (...) (23 years ago, 9-Oct-01, to lugnet.robotics)
|
3 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
