 | | IR Tower problems
|
|
I recently purchased an IR tower to use with my Scout. It did not come with a cable, but the tower was only 6$(www.eblok.com), so I found a cable that could plug into the back of it. The other end of the cable fit into the printer plug on the back (...) (25 years ago, 21-Jan-01, to lugnet.robotics)
|
| |
| | Beta Release of MacNQC
|
|
Hi all, I have been working on an updated version of MacNQC and am now ready for a public beta. If you are interested in it, it can be found at (URL). There are some new windows to control the RCX and the compile has been updated to NQC 2.2r2. Rob (...) (25 years ago, 20-Jan-01, to lugnet.robotics)
|
| |
| | Re: Palmpilot and RCX
|
|
(...) I've just read that version 1.2 of the program will have a programmers interface. Would this allow NQC to be ported to it and be useable for Downloading Firmware, Uploading programs and sending msg codes? With a Visor Platinum would I be (...) (25 years ago, 20-Jan-01, to lugnet.robotics)
|
| |
| | Gearing down a lego motor
|
|
Hi, Before I invest a lot of time on this, what is the minimal gearing I need to do in order for a Lego motor to let itself up. How about a lego motor lifting itself and another motor up? I want the motor to be powerful but at the same time fast... (...) (25 years ago, 20-Jan-01, to lugnet.robotics.rcx, lugnet.robotics)
|
| |
| | Re: adder-subtractor ????
|
|
Could you give some directive to the maximum size of it in 'bricks'? It would be a challenge to make a small adder-subtracter with a small basis, although it would probably mean that it will become a little higher than usual. Jeroen. ___...___ Visit (...) (25 years ago, 20-Jan-01, to lugnet.robotics)
|
