Subject:
|
difference of generated code robolab<->NQC
|
Newsgroups:
|
lugnet.robotics
|
Date:
|
Sat, 2 Dec 2000 16:44:24 GMT
|
Original-From:
|
el nino <[e.nino@]Spamcake[gmx.net]>
|
Viewed:
|
847 times
|
| |
|
|
hi,
i need to know if there is a difference between the code generated by
Robolab and NQC.
Both are running with the standard RCX Firmware, i also know that the
compiled code of both
is interpreted by the firmware.
-> is the generated code the same ?
-> can i proof with wich tool the software was made, when i only have the
programmed RCX Brick ?
THX Patrick
P.S. sorry 'bout my bad english
|
|
Message has 1 Reply:
 | | Re: difference of generated code robolab<->NQC
|
| (...) They both generate the same "kind" of code (specifically LASM bytecodes), but its unlikely that code would be identical. I'm sure there are certain patterns of code that are typical from Robolab programs, and certain patterns that are typical (...) (24 years ago, 3-Dec-00, to lugnet.robotics)
|
2 Messages in This Thread:
 
- Entire Thread on One Page:
- Nested:
All | Brief | Compact | Dots
Linear:
All | Brief | Compact
|
|
|
|
