 | | Recipricating motion problems
|
|
I have two 24 tooth gears. The lower gear is one hole down, six holes over from the upper gear. Like so (the @ are where the center of the gears are): @ @***** ^1 2^ I need to make it so that by turning gear 1 continusaly, in only one direction, (...) (24 years ago, 30-Nov-00, to lugnet.robotics)
|
| |
| | Re: Recipricating motion problems
|
|
You need gears or a cam that allows an adjustment in the distance from the centerline of the shaft. A 24 tooth gear and a 40 tooth gear would allow you to accomplish such action. I find the cam is very useful as the driven element. You can always (...) (24 years ago, 30-Nov-00, to lugnet.robotics)
|
| |
| | Re: Recipricating motion problems
|
|
sorry but you lost me, whats a cam? If you mean an off center 40 tooth gear, i already tried that but it didn't work. i could get it to turn th other , but i could get it to turn it back again Jason (...) (24 years ago, 30-Nov-00, to lugnet.robotics)
|
| |
| | Re: Recipricating motion problems
|
|
This is a little short of 90 degrees. (URL) Fay rfay@we.mediaone.net The Shop (URL) Stern" <2busytobe@home.com> wrote in message news:3A2687F4.B93568...ome.com... (...) gear, i (...) but i (...) the (...) you (...) the (...) sure (...) supposed (...) (24 years ago, 30-Nov-00, to lugnet.robotics)
|
