To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *9791 (+5)
  I have made a i2c routine for the handy board
 
Hello, You want to use the i2c bus (by the SPI connector) with your handy baord ? I have made a routine to use i2c component (PCF 8574, 8591.......) with the handy board. Do you want it ? See you later. Dperonne@aol.com (28 years ago, 28-Feb-99, to lugnet.robotics.handyboard)
 
  Slope in NQC
 
Hi Everyone, Can anyone tell me what is the NQC equivalent of the slope parameter in the Spirit.OCX SetSensorMode command. Thanks, David Strike -- Did you check the web site first?: (URL) (28 years ago, 28-Feb-99, to lugnet.robotics)
 
  Re: Slope in NQC
 
(...) Making mine Dave Baun's words: I think you can already change the slope with the existing calls. Just add the slope to the mode constant... SensorMode(IN_1, SMODE_BOOL + 10); The slope should be between 0 and 31 (inclusive). :-) Laurentino (...) (28 years ago, 28-Feb-99, to lugnet.robotics)
 
  Re: Working with Legos
 
Some of the sensors that I've used easily attach to the the plates & hlocks with holes using a set of tiny nut, bolts, and washer(s). No damage done to any of the components, and easy to change your mind about where you're going to put it. -kr (28 years ago, 28-Feb-99, to lugnet.robotics.handyboard)
 
  Re: Working with Legos
 
I glued a couple of the thin Lego strips to the bottom of my HandyBoard to make it quick and easy to plop the board firmly onto a Lego base yet still have it easily removable. Doing this you must be certain to get the correct Lego spacing, so first (...) (28 years ago, 28-Feb-99, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR