 | | Re: building a bot
|
|
From your post it seems that only one battery was used. It is best to have the motor(s) running from a separate battery. Apropriate capacitors for RF noise and large start up currents should be considered. Have fun! (...) Peter (...) ---...--- Ed (...) (30 years ago, 12-Nov-96, to lugnet.robotics.handyboard)
|
| |
 | | R/C cars as robot chassis
|
|
Here is a rule of thumb to keep handy when converting R/C cars to robots; o If the R/C car used either NiCd batteries, or it had a NiCd battery pack, the motors will draw too much current for the Handyboard. This is strictly true of any controller (...) (30 years ago, 12-Nov-96, to lugnet.robotics.handyboard)
|
| |
 | | Pyroelectric Detectors
|
|
I'd like to incorporate a pryroelectric IR detector into my robot design. "Mobile Robots" has some detail on sensors, but I'd like to keep it cheap. I have an out-of-service Heath/Zenith motion detector lying about - is the sensor within similar to (...) (30 years ago, 12-Nov-96, to lugnet.robotics.handyboard)
|
| |
 | | Servo_a5
|
|
Hi, I'm using IC v3.1 beta 4. When I try to load the servo_a5.icb and the servo_a7.icb that I downloaded from the handyboard web page I get the following error: Fatal internal error: Illegal line in .s19 file And then it completely kicks out of IC. (...) (30 years ago, 12-Nov-96, to lugnet.robotics.handyboard)
|
| |
 | | Re: Servo_a5
|
|
Maria, Can you follow the instructions for prepping ICB files at (URL) let us know if that solves the problem? I had been told that this problem was solved in the 3.1 versions of IC, but perhaps not. Thank you, Fred In your message you said: (...) (30 years ago, 13-Nov-96, to lugnet.robotics.handyboard)
|