 | | More information for debugging my problem
|
|
I'm the one with the dead HB. When I look at R14 (next to the SPI header) it is black and is very hot. Do I have a dead resistor? Thank You Peter Eacmen BLS petereacmen@usa.net (28 years ago, 30-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: Killough's mobile robot platform
|
|
(...) This design will have R2C2's chip set smoking with envy! But it's a platform - so before I buy the missing pieces - how much mass can it carry? Franz-Michael S. Mellbin ----- fmm@fischer-mellbin.com (URL) (28 years ago, 30-Jan-99, to lugnet.robotics)
|
| |
 | | Two piece light sensor.
|
|
Greetings, Well I finally succeeded. I have created two piece light sensor emitter pair. To do this I took the basic light sensor circuit of Malcolm S. Powell (see (URL) and broke it into two pieces. I built the emitter in one brick and the detector (...) (28 years ago, 30-Jan-99, to lugnet.robotics)
|
| |
 | | Re: measure motor torque with a light sensor
|
|
(...) I think this will only work with CM, lights are powered by the RCX and this will probably run the motors all the time. I guess a touch sensor in raw mode would do it, but wouldn't return anything like 0 and 100. What happens when a motor is (...) (28 years ago, 29-Jan-99, to lugnet.robotics)
|
| |
 | | The ultimate in IR proximity detection (when calibrated)
|
|
We have designed a fast moving Mindstorms robot which tends to hit things before seeing them using most of the IR proximity detector implementations published. I was thinking about the recording of an RCX message by video camera on Simen Svale (...) (28 years ago, 29-Jan-99, to lugnet.robotics)
|