 | | Re: Sensor monitoring
|
| (...) that (...) What about using homebrew light sensors made from CdS photoresistors? Seems like it would be possible to multiplex them since they don't require power. (28 years ago, 23-Jan-99, to lugnet.robotics)
| | |  | | Re: RCX message's
|
| Rudi Slomp skrev i meddelandet <36A92700.4A0B@iaehv.nl>... (...) I think these are Mindstorms specific - sending messages through the IR port. -- Anders Isaksson, Sweden BlockCAD: (2 URLs) (28 years ago, 23-Jan-99, to lugnet.robotics)
| | |  | | Re: Ultrasonic sensor
|
| (...) Firstly, it looks like the sensor board can be powered from the HB using the motor power header (J13). This is good, because the two should share a common ground. Based on the schematic and the web page description, it looks like this type of (...) (28 years ago, 23-Jan-99, to lugnet.robotics.handyboard)
| | |  | | Re: senor signal line back to HD
|
| (...) The sensor should be grounded to the HB. (...) Oh yes. Quite a few messages this past week suggest how to avoid frying your sensor ports with excessive voltage. -- Will , , __@_/ \_@__ |/ | /__, o @_/ )\ ) ( \ (\/\\, ~~~...~~~ ' ` ~~~...~~~ ` (...) (28 years ago, 23-Jan-99, to lugnet.robotics.handyboard)
| | |  | | Stack Overflow
|
| Hi everyone: I'm trying to download a rather large chunk of code to the HandyBoard, and I'm having a problem when I exceed a certain number of instructions in a procedure I'm running. When I try to download the code, I get the error "yacc stack (...) (28 years ago, 23-Jan-99, to lugnet.robotics.handyboard)
| |