To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *8326 (+5)
  Re: homebrew Temp sensor
 
(...) I damn well know what an elco is, thank you, and, I've never seen one blow up from <12V.. they can get a bit hot, and make a little plop, but I've personally never seen them shower the room with shrapnel. Which of course, is not saying that (...) (28 years ago, 23-Jan-99, to lugnet.robotics)
 
  Re: Pneumatic Tanks
 
(...) The heroine dealer on the corner? Jasper (28 years ago, 23-Jan-99, to lugnet.robotics)
 
  Re: Toy motors
 
right, this is a good answer. you buy a device called an "electronic speed controller". this connects like a servo to the HB (3 wire connection) and has outputs to drive high current DC motors. you also connect a separate power supply to the device. (...) (28 years ago, 23-Jan-99, to lugnet.robotics.handyboard)
 
  Re: Working around the 3 output limitation
 
(...) The one with two studs in the middle, and two holes at the ends? and you then have one of the half-bushings with teething (1) thaty it rests on? I would say that those teehings are too deep too slip comfortably, but I haven't tried it out. (1) (...) (28 years ago, 23-Jan-99, to lugnet.robotics)
 
  Re: Toy motors
 
sorry, send my msg before it was done. right, this is a good answer. you buy a device called an "electronic speed controller". this connects like a servo to the HB and has outputs to drive high current DC motors. you also connect a separate power (...) (28 years ago, 23-Jan-99, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR