To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *7716 (+10)
  Book on Robot Sensors and Navigation Techniques.
 
Thanks to Carl Schaefer for posting the URL for the Robotics Reference entitled: Where am I? Sensors and Methods for Mobile Robot Positioning by J. Borenstein , H. R. Everett , and L. Feng I have looked into the Table of Contents and have begun (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Cut Price Mindstorms in the UK...
 
I hate - and I do mean *HATE*, paying full price for anything and would like to get a couple of Mindstorms kits for educational purposes (OK, OK, I'm going to play with them) but everywhere I look [here in the UK] has them at the full RRP of (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Wireless Handyboard Link ?
 
Hello, I am investigating createing a wireless serial link between my PC and handyboard. The cheapest solution I've found is the RF module from Lynxmotion. Does anyone have any experience with this, or perhaps suggestions for simpler or more (...) (28 years ago, 11-Jan-99, to lugnet.robotics.handyboard)
 
  More small changes to firmdl.c
 
Two more small changes to firmdl.c. Gavin Smyth reported seeing long delays while downloading firmware, and suggested a fix that may or may not have much effect, depending on your system. That fix, which limits the number of response bytes waited (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Re: RCX 2.0 -- ideas.
 
(...) I'd take a couple if they were in the $15 dollar range. -Blake -- Did you check the web site first?: (URL) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Expansion board motor outs???
 
I just wanted to verify something before I went and purchased the expansion board. Are the HB's motor outputs still available when using the expansion board. It is unclear in the doc. Thanks, Aaron (28 years ago, 11-Jan-99, to lugnet.robotics.handyboard)
 
  Fw: RcxCC Joystick controls
 
Very simple. Write a little nc program that defines some tasks. Download it to the robot but don't run it. Here is a trivial example. After downloading it, the first button will start motor B and the second button will stop it. (Note that the order (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Re: Pneumatic Tanks
 
(...) :-) (...) Syringes? That's injection needles, right? Hm. Now where do I get disposable syringes? Ah, I figure I'll find something I can use somewhere. Thanks for the idea! Fredrik (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  Re: ideas?
 
This should have worked - are you sure that you replaced your old Menus folder with the one in the extras folder? see ya (...) Associate Professor Department of Mechanical Engineering Tufts University Medford, MA 02155 email: crogers@tufts.edu (...) (28 years ago, 11-Jan-99, to lugnet.robotics)
 
  motor ports
 
Hi all, Is it possible to add more motor ports to the handy board by simply copying the existing motor drive circuit and putting them on the expansion header where the extra chip select lines are. if so what changes would be needed to make IC (...) (28 years ago, 11-Jan-99, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR