 | | Re: 3 sensors = 8 inputs?!
|
|
(...) Unless you add a bit of electronics to multiplex your sensors, use the existing three digital inputs as a mini parallel port, design a simple communications protocol and send the sensor statuses from the module to the RCX using the protocol. A (...) (28 years ago, 7-Jan-99, to lugnet.robotics)
|
| |
 | | supplier for Sharp IS1U60 infrared demodulator
|
|
Hello Folks- A couple of months ago I built a HB with the exception of one part... U15 (Sharp IS1U60 infrared demodulator) ... I now have the need. I am looking for the info for a supplier or individual that will sell a small number(2). I'm in the (...) (28 years ago, 7-Jan-99, to lugnet.robotics.handyboard)
|
| |
 | | Re: 3 sensors = 8 inputs?!
|
|
(...) The way the inputs work does not allow hooking something up to two inputs at the same time while still keeping independent use of the inputs. You would need to add at least diodes. I assume you want a pure LEGO solution, but LEGO doesn't have (...) (28 years ago, 7-Jan-99, to lugnet.robotics)
|
| |
 | | 2 Motors off one output???
|
|
I'm sure that this has been covered before, but!!! Has anyone (or can it be done) hooked two motors(i want them to move in the same direction) up to one of the "A", "B", or "C" outputs. Clay Aucoin Director of Information Technologies, Web Services (...) (28 years ago, 7-Jan-99, to lugnet.robotics)
|
| |
 | | Re: CM in LDraw
|
|
(...) Answering my own post: I was told L3P ((URL) can make the edges disappear when rendered with POV-Ray ((URL) trick is to put the DAT file into the PARTS directory. Laurentino Martins *<||:-) [mailto:lau@mail.telepac.pt] [(URL) you check the web (...) (28 years ago, 7-Jan-99, to lugnet.robotics)
|