To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *7206 (-5)
  Small but useful change to firmdl.c
 
Further moping though the ROM image revealed that the address in the start firmware download message is really the firmware entry point. I modified firmdl.c to take this into account. If an entry point is stored in the s-record file, firmdl.c uses (...) (28 years ago, 2-Jan-99, to lugnet.robotics)
 
  RE: legOS ... really a stack question
 
(...) .bss also contains global data initialized to 0, which is even worse if it's not cleared. -Allen -- Did you check the web site first?: (URL) (28 years ago, 2-Jan-99, to lugnet.robotics)
 
  Re: legOS ... really a stack question
 
(...) All off-chip accesses to f000 or higher are memory mapped to the motors. Because accesses to addresses above fb7f are all on-chip or invalid, the motors are effectively memory mapped to f000-fb7f. (...) What are your symptoms again? One (...) (28 years ago, 2-Jan-99, to lugnet.robotics)
 
  Re: legOS ... really a stack question
 
(...) Looking at my memory map, it appears that there is space for the stack in on-chip memory between fdc0 and ff7e (or thereabouts). That's just about 450 bytes. If you need more stack space than that, you'll need to move the stack to off-chip (...) (28 years ago, 2-Jan-99, to lugnet.robotics)
 
  another question
 
Also, how do you switch the light sensor from reflective mode to ambient mode? I suspect that the LED is what's already run down my batteries, and I don't read reflected light, I read ambient light anyway. -- +---...---] | Ickna / Nick H. | (URL) (...) (28 years ago, 2-Jan-99, to lugnet.robotics)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR