To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *706 (+5)
  RE: -POWER GLITCH- message
 
(...) One possibility: make sure you have loaded pcode_hb.s19 onto the board, and *not* pcoder22.s19. I've reloaded the correct version of the IC into the HB and it looks like it works fine. Thanks again Oriol ------- End of Forwarded Message (30 years ago, 16-Aug-96, to lugnet.robotics.handyboard)
 
  Servo information
 
Can somebody tell me the power requirements for a SANWA SRM-101 servo that I took from a RC car ? Thanks Oriol (30 years ago, 16-Aug-96, to lugnet.robotics.handyboard)
 
  POWER GLITCH msg
 
for edification, Oriol reported that the problem was loading the wrong pcode... -Fred ------- Forwarded Message (30 years ago, 17-Aug-96, to lugnet.robotics.handyboard)
 
  (no subject)
 
unsubscribe handy board wcm@tbscc.com ---...--- Nicholas Willam McQuiston General Geek <wcm@tbscc.com> (30 years ago, 17-Aug-96, to lugnet.robotics.handyboard)
 
  Shaft Encoders
 
(...) Hello, I'm new to the Handy Board mailing list. I have been browsing through the archives and I saw the discussion regarding shaft encoders. I haven't seen anyone use the technique I've used rather well. Like the thread suggests, I've tried (...) (30 years ago, 18-Aug-96, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR