 | | RE: sensor input mux calculations
|
|
Duh. I didn't notice that the switches were in parallel with the resistors. Dang proportional fonts in email. Sorry about that. Yes, it would work nicely and is generally what others have been thinking of, just not putting down in drawings. Rob/Duh (...) (28 years ago, 30-Dec-98, to lugnet.robotics)
|
| |
 | | RE: sensor input mux calculations
|
|
This design would prevent multiple switch detection. Only one switch would be detectable (the last one). The designs people have been creating so far have been capable of detecting 3-4 discrete inputs at any time regardless of the settings of any (...) (28 years ago, 30-Dec-98, to lugnet.robotics)
|
| |
 | | Squeezing 4 inputs out of 1
|
|
I've constructed a circuit that will read four switches from one input port. Theory- The input port is an A/D circuit. It reads voltage as opposed to state. The A/D line is wired to a 10K ohm resistor that is in turn wired 5 volts. Thus if it is (...) (28 years ago, 30-Dec-98, to lugnet.robotics)
|
| |
 | | Squeezing 4 inputs out of 1
|
|
I've constructed a circuit that will read four switches from one input port. Theory- The input port is an A/D circuit. It reads voltage as opposed to state. The A/D line is wired to a 10K ohm resistor that is in turn wired 5 volts. Thus if it is (...) (28 years ago, 30-Dec-98, to lugnet.robotics)
|
| |
 | | 99 Catalog scans complete
|
|
well, all done scanning them, where to put them? there is a total of 2.61 MB of them, all the new ones up to the Search and Rescue Complex (P 29), will scan the rest tommorw, I ran outta space on my C: drive, where the scanner software holds a temp (...) (28 years ago, 30-Dec-98, to lugnet.general, lugnet.robotics)
|