|
|
 | | Re: Handyboard Kit.
|
| (...) That is a mistake in the directions. They should be 47uF axials, like you have. I will fix this now. -Fred (29 years ago, 17-Jul-96, to lugnet.robotics.handyboard)
| | | | | encoders
|
| (...) if your counting program is written in IC, and not assembly lang, it might be too slow and occasionally miss counts. -F (29 years ago, 17-Jul-96, to lugnet.robotics.handyboard)
| | | | | Servo Motor
|
| Hello! Could anybody please tell me the proper step in controlling the servo motor by HB ? ^s I connected the servo motor to the HB and typed in the servo motor control functions but none of them are working... Thanks in advance. (29 years ago, 17-Jul-96, to lugnet.robotics.handyboard)
| | | | | Where can I get GP1U52X IR sensors?
|
| Hello there Handyboard users in the world, I read a lot about these IR sensors: Sharp GP1U52 or GP1U56Y. I would like to use some of these sensors in my own robot, that I build around a 8051 and a Forth interpreter. Now it has a few bumper switches (...) (29 years ago, 17-Jul-96, to lugnet.robotics.handyboard)
| | | | | Re: Servo Motor
|
| Hi Hajime, Here's the rundown for connecting the servo to the Handy Board: 1) Assuming you're using digital port 9, you will need a connector like this: _ =====| |== <--- connect the WHITE wire from the servo here | | <--- remove pin to polarize (...) (29 years ago, 18-Jul-96, to lugnet.robotics.handyboard)
|
|
