To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *6216 (-5)
  Re: 2 RCX communication on the same model
 
(...) You mean the RIS/GUI language? It _does_ have an IR message function. (28 years ago, 10-Dec-98, to lugnet.robotics)
 
  Servos for the miniboard
 
I would like to use a servo to operate the throttle of a small gas engine. I am planning on using the miniboard to control the servo. Are there any brands to avoid? Are there any brands that are far better than the rest? Will just about any RC servo (...) (28 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
 
  How to get digital outputs from the handyboard???...???
 
hi everyone, i have been trying for the past few days to get digital outputs from the board but with no success. i have been trying to get digitals outputs from the SPI's pins (J6). i have poke to make the port as output port. but the problem now is (...) (28 years ago, 10-Dec-98, to lugnet.robotics.handyboard)
 
  Re: Out of range
 
Hi, I have some code that does this but it get kind of complicated to explain but here goes.... 1. I have a separate thread in my (C++) app that is used to poll the cybermaster variables. I can set which variables to check under program control. 2. (...) (28 years ago, 10-Dec-98, to lugnet.robotics)
 
  How to get digital outputs from the handyboard???...???
 
hi everyone, i have been trying for the past few days to get digital outputs from the board but with no success. i have been trying to get digitals outputs from the SPI's pins (J6). i have poke to make the port as output port. but the problem now is (...) (28 years ago, 10-Dec-98, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR