 | | Re:
|
|
Hi everyone, The mistake you make in your calculation is that in your calculation you take the entire 15V for the resistor and this leaves no voltage for charging your NiCad. Do the same thing again and deduct your NiCad voltage from the 15V you (...) (28 years ago, 14-Nov-98, to lugnet.robotics.handyboard)
|
| |
 | | Cybermaster protocol?
|
|
Does anybody have information on the basic Cybermaster packet protocol handy? How does it differ from the 55 ff 00 D ~D D ~D C ~C format of the RCX? -Kekoa (28 years ago, 14-Nov-98, to lugnet.robotics)
|
| |
 | | Re: moving in a straight line with two motors?
|
|
(...) Believe it or not, I've been working on exactly this problem for the last few days. I built an angle sensor using a 500K potentiometer wired directly to an RCX input port. (Lego's angle sensor doesn't have sufficient angular resolution unless (...) (28 years ago, 14-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Homebrew sensors?
|
|
(...) So's Michael - he's proposing a notch filter so you get the amplitude at a particular frequency, which may be better for a seeking application. Cheers, Ben. (28 years ago, 14-Nov-98, to lugnet.robotics)
|
| |
 | | Re: moving in a straight line with two motors?
|
|
(...) I think making the pendulum longer should cure this... (...) Possibly making it heavier will cure this... Cheers, Ben. (28 years ago, 14-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Homebrew sensors?
|
|
In article <Pine.GSO.3.96.98111...129.6050E- 100000@expert.cc.purdue.edu>, Daniel Miller <danielmi@expert.cc.purdue.e du> writes (...) Ah. A jet engine expert. It always puzzled me how the hot air knows it is supposed to go out of the hole at the (...) (28 years ago, 14-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Homebrew sensors?
|
|
does pressure difference make any sense?..:-) Selçuk (...) (28 years ago, 14-Nov-98, to lugnet.robotics)
|
| |
 | | Re: NiCd Charger
|
|
Russ: In a message dated 98-11-13 04:48:38 EST, you write: << ... power rating of resistor = 15Volts * 200mA = 3Watts Series resistor needed = 75 Ohms @ 3 Watts. ---...--- ------- The 75 Ohms bit seems reasonable to me but 3Watts must be way to (...) (28 years ago, 14-Nov-98, to lugnet.robotics.handyboard)
|
| |
 | | Re: moving in a straight line with two motors?
|
|
---...--- (...) attached. (...) is (...) is (...) sheet (...) I expect that the "motor is shorted" state is achieved by turning on either both high-side drive FET's or both low-side drive FET's, and niether of these combinations would provide a high (...) (28 years ago, 14-Nov-98, to lugnet.robotics)
|
| |
 | | Re: Cybermaster protocol?
|
|
(...) If I'm not mistaken, Peter Ljungstrand has compiled this information at (URL) (28 years ago, 14-Nov-98, to lugnet.robotics)
|