To LUGNET HomepageTo LUGNET News HomepageTo LUGNET Guide Homepage
 Help on Searching
 
Post new message to lugnet.roboticsOpen lugnet.robotics in your NNTP NewsreaderTo LUGNET News Traffic PageSign In (Members)
 Robotics / *506 (+5)
  (no subject)
 
I'm having a little truoble with the H-Bridge described in this mailgroup. I have MOST of the circuit OK.. The power bridge itself, Diodes, etc.. I am also OK with the optocouplers to 2n2907s.. I am just a bit confused with the description if the (...) (30 years ago, 6-Jun-96, to lugnet.robotics.handyboard)
 
  Re: your mail
 
Yes, the h-bridge circuit is very, very, very confusing. Hmm. Well it's in my robot right now, so lemme see if I can remember how it works. Ok, let's see. First, you connect both of the emitters of the PNP power transistors to +6V or whatever. (...) (30 years ago, 6-Jun-96, to lugnet.robotics.handyboard)
 
  (no subject)
 
Hi! Would you please let me know the input impedance of the AD circuit ? Thanks in advance. hajime (30 years ago, 7-Jun-96, to lugnet.robotics.handyboard)
 
  (no subject)
 
(...) all sensor inputs have a 47K pull-up resistor. If you remove this (by cutting the trace between the sensor input pin and the 47K resistor pack), then the analog inputs are pretty high impedence, like a meg or so. You should get the "M68HC11 (...) (30 years ago, 7-Jun-96, to lugnet.robotics.handyboard)
 
  are you a graduating student?
 
If so, please me know if your e-mail address is about to be blown away. I've noted a surge in bad addresses on the list from the .edu sites. also, this is a reminder to all that the way to unsubscribe is to find your e-mail address by clicking the (...) (30 years ago, 7-Jun-96, to lugnet.robotics.handyboard)

Next Page:  5 more | 10 more | 20 more
Redisplay Messages:  All | Compact

©2005 LUGNET. All rights reserved. - hosted by steinbruch.info GbR